Genuine Honda Product
Direct Factory Replacement Part
Pre-Installed Double Sided Adhesive
Compatible with 02-06 RSX, 04-08 TL/TSX, and 96-04 RL

Description
Vehicle Fitment
Included

Acura RL/RSX/TL/TSX Rear Emblem - 75711-SZ3-A00

Got a faded, missing, or falling-off Acura badge on the back of your car? The Acura rear emblem (part number 75711-SZ3-A00) replaces your old emblem and makes the back of your car look factory fresh again. Your factory emblem gets destroyed from years of sun exposure, car washes, and road grime. The chrome fades, the lettering discolors, and the adhesive fails so the badge falls off or it's hanging on by one corner. The new emblem comes with double-sided adhesive pre-installed on the back. You're peeling off your old emblem, cleaning the surface, and sticking the new one on. Takes two minutes.

Here's Why Your Factory Emblem Looks Like Crap

Your factory Acura emblem's been sitting on the back of your car for 20+ years getting cooked by the sun and blasted by road salt and car wash chemicals. The chrome finish oxidizes and fades. The black lettering discolors or it starts peeling off. The adhesive backing gets old and fails, so your emblem's either hanging loose or it already fell off somewhere. A new emblem makes your car look way cleaner. If the previous owner removed the badge and you want to put it back to stock, this is the factory emblem.

Pre-Installed Adhesive

The emblem comes with double-sided adhesive already installed on the back. You're not buying separate adhesive or using glue. Peel the backing off the adhesive, line the emblem up where your old one was (or where it's supposed to go if it's missing), and press it on. That's it. Make sure you clean the surface with rubbing alcohol before you stick the new emblem on. If there's wax, oil, or grime on your trunk, the adhesive won't stick properly and your emblem's going to fall off.

What You Get
- Acura rear emblem
- Part number: 75711-SZ3-A00
- Genuine Acura OEM replacement
- Chrome finish with black "ACURA" lettering
- Pre-installed double-sided adhesive backing
Originally Equipped On
- 1996-2004 Acura RL
- 2002-2006 Acura RSX
- 2004-2008 Acura TL
- 2004-2008 Acura TSX
Note: Clean your trunk or hatch with rubbing alcohol before you install the new emblem. If there's wax, dirt, or oil on the surface, the adhesive won't stick and your emblem's going to fall off. Don't install the emblem in cold weather. If it's below 50 degrees outside, the adhesive won't bond properly. Wait for a warm day or bring your car inside somewhere warm before you install it. Once you stick the emblem on, press it firmly for 30 seconds to make sure the adhesive bonds. Don't wash your car or get the emblem wet for at least 24 hours after you install it. The adhesive needs time to cure.
1996-2004 Acura RL
2002-2006 Acura RSX
2004-2008 Acura TL

2004-2008 Acura TSX
(1) Rear Acura Emblem

Emblems

Acura CL/RSX/TL Type S Rear Emblem 75731-S3M-A10

Acura RL/RSX/TL/TSX Rear Emblem 75711-SZ3-A00